Monday, July 28, 2014

ISORG Presentation

ISORG published its presentation at Printed Electronics Show held in April 2014 in Berlin, Germany. Few slides talking about the company's plans and vision:

8 comments:

  1. Watch out Amorphous silicon panels! This sounds like a disruptive technology for that market.

    ReplyDelete
  2. What is the fundamental advantage compared to a-Si X-ray panel please ?
    From my understanding, this polymer photodiode needs thin-film transistor for readout. In this case, only if this polymer photodiode is much better than a-Si photodiode, otherwise the advantage is limited. Thanks !

    -yang ni

    ReplyDelete
  3. I would postulate that one advantage of OPDs for X-ray imaging appls. might be alternate scintillator-detector configurations - e.g. "back screen configuration" originally used in Screen-Film radiography -
    Here, the x-rays travel through the detector, excite the phosphor and the light is shone back onto the detector.
    For some X-ray energies, this would not be possible in TFTs, because the silicon and glass substrate would attenuate the signal too much, but the organic substrates would be much more transmissive

    ReplyDelete
    Replies
    1. I suppose that if TFT can be done soft polymer substrate, then we can have a plexible X-ray detection sheet. That is very interesting in this case. Is this possible ? Thanks !

      -yang ni

      Delete
    2. Yang,

      We looked into this when I ran Varian's Imaging Systems group around 2000. Uniax had already made a line scan device using polymer photodiodes on glass and the first pentacene transistors had been fabricated. Mobility wasn't quite good enough but it is now. There was also a company (I can't remember the name now) setting up for roll-to-roll processing of amorphous silicon on plastic for displays.

      I haven't really evaluated the state of the technology in a while but it should now be possible to make all-polymer photodiode/TFT arrays on flexible substrates. Couple this with standard Gadox film intensifying screens and shoudl be possible to build extremely rugged radiographic and fluororscopic panels.

      My guess is that they don't exist largely due to the lack of the necessary infrastructure.

      Delete
    3. Thanks Dave ! My dentist said that CMOS has local image distortion (probably due to FOP on the sensor) which is very troublesome in fine observation. Phosphor plate (which is new in dental use, it was a patent of Hitachi, if I remember well ...) has no distortion and also the resolution can be adjusted by laser scanning. It is also very flexible and comfortable. He told me that the CMOS sensor head has to be changed every 5 years for 5000 euros and the phosphor plate costs only 50 euros, so very competitive product any way. The scanner is expensive.
      -yang ni

      Delete
    4. The first CR patent (US 3,859,527) was issued in 1975 to George Luckey at Eastman Kodak. Fuji produced the first commercial CR product. If I rememeber correctly, the first dental CR scanner was put out by a company in California (whose name I can't remember) in the late 90s about the time that Lumisys came out with their full-size desktop scanner.

      Delete
    5. Dave, thanks so much for this information !!

      -yang ni

      Delete

All comments are moderated to avoid spam and personal attacks.